Reply To: Printing the 3DPCB

Home Forums LEET Synthesizer – Support Printing the 3DPCB Reply To: Printing the 3DPCB


I appreciate you taking the time to help me, I have never had this much issue with a print before. I just can’t seem to get past the first 6-8 layers to get a solid print. I rarely have issues like this, my calibration cubes are almost spot on 20mm.

I have no doubt it is the slicer, but I have tried multiple versions of Cura (4.1, 4.7.1) and I just get strange travel or strange stringing/trailing issues on layer 1 that I don’t see when I run a string test or other printing tests.

I am going to see if I can’t tune one of my printers this weekend and try again…