Xenomania_NL

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2020/11/09 at 09:32 in reply to: User gallery – share your builds #1667
    Xenomania_NL
    Participant

    But love the end result. Sliced in prusa slicer alpha 2.3.0 with a “monotonic” infill on top. Pro micro’s are ordered so hope they arive soon. Started a new print this morning with a other collor on a smooth PEI sheet instead of the textured one. Lowered the speed a little bit more to 66%.

    Front

    Thanks again for sharing this project on the internet.

    2020/11/09 at 09:27 in reply to: User gallery – share your builds #1666
    Xenomania_NL
    Participant

    But after lowering the nozzle (Z hight) just a little and slowing down the print to 75% we had succes :) . The smaller parts between the buttons were hard to stick to the printbed.

    back

    2020/11/09 at 09:25 in reply to: User gallery – share your builds #1665
    Xenomania_NL
    Participant

    To start first of all thanks for sharing this project.

    Unfortunatly my first print was a Fail (see below). Luckly a sting did stop on of the fan’s stopping the print and saving me from a blob on my hotend.

    First Fail

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)