[CWStevens]

0.3mm is roughly 28awg buss wire.  0,0126″ == 0.32mm

I plan on using this: https://www.amazon.com/gp/product/B01BDA7DO6

Chris

[CWStevens]

The 1-layer between the top controls and bottom led strip appears to be a hair too thin to print with a 0.4mm nozzle.  (Prusaslicer, MK3s, Pet-G  thin-wall detection off and on yielded same results.)

Chris

[CWStevens]

What’s the recommended way to access the bottom pad through the adhesive?  X-acto knife to gently remove the adhesive and expose the pad?  Use a solvent like goof-off or acetone on a q-tip?

(My apologies if this is covered in the construction notes…  I’m not quite there yet.)

And I’m going to use WS2812’s, not WS2182’s.  ;-)

Thanks, Chris

[CWStevens]

In addition to the 2.3.0 alpha’s monotonic infill, try enabling “ironing”.  Only the top-most layer is really necessary.  Orange is monotonic-without, blue and pink are monotonic and ironed on the top-most layer.

Chris

[Author]

Posts